Controller for 5KW Coolant Boat Heater

VEHICLEAC controller dedicated for 5KW coolant water diesel heater, 5KW parking liquid heater controller special accessories

The chip control system of 5KW coolant heater controller based on CAN communication realizes precise control of the heater and instant communication of data. At the same time, remote control can be realized for our parking diesel water heater
 

How to Right Connecting 5KW Coolant Heater Controller Plug-in Installation Sequence Video

 
 

How to Correct Connecting the Controller Wiring of 5KW Parking Coolant Liquid Water Heater

              picture 1                                                    picture 2                                                    picture 3                                            picture 4
Picture 1.  Install the parking heater motor plug-in    
Picture 2.  Install the ignition sensor plug-in of truck cab heater
Picture 3.  Install the glow plug of truck cabin coolant heater
Picture 4.  Install the controller of 5KW Boat coolant heater

1.Connect the heater motor plug-in (Red, black, blue and green four wires), and put it in the wiring harness plug-in placement position on the left side of the coolant heater motor (see the picture 1)
2.Insert the ignition sensor plug-in of parking heater (Red and white two wires) and place it in the position where the wiring harness plug-in is placed (see the picture 2)；
3.Then connect the glow plug-in unit (Two relatively thick wires, yellow and green ) and place it in the place where the wiring harness plug-in unit is placed (see the picture 3)；
4.Finally, install the controller of 5KW parking diesel coolant.(see the picture 4)                 
★Pay attention to the reasonable placement of the wiring harness when installing the controller, and carefully check that the wires cannot be pressed when installing & tightening the controller.